I'm using the speaker to monitor the pedal again, and the interface just has a microphone plugged into one of the inputs at the moment. I've recently changed the setup so the interface and pedal are pretty much separate. I've also noticed that when the gain on the 2i2 is just below clipping, it is significantly quieter when recorded into my DAW through the USB on the interface, than when I just record through the USB on my HD500x, does this mean my tone patches are too loud? This was basically just so I could run the audio from my PC and my guitar through the same set monitors. Since getting my 2i2, up until now I've just had the signal from my pedal running into both inputs on the 2i2 through XLR cables. In the past I always recorded through the USB of my Pod, running a separate speaker to hear it. ![]() I'm using a Pod HD500x and could do with a bit of technical expertise. I bought a Focusrite Scarlett 2i2 a little while back and am trying to figure out how best to use it with my rig.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |